BAT/Script not working while CL does
Hi All -
So, every day, I move a file from my network to my client's bank. I've recently upgraded my server and move my scripts over to the new server. This WAS working on the old server.
Set up is this:
Task Scheduler executes a .bat file which runs a WinSCP script.
WinSCP Script is as follows:
.Bat file text which executes this follows:
When I open a command line session with the bank, entering those commands one by one works perfectly. When I run the .bat file (even if I run it as an admin) it does not.
Any ideas? Anything I can do to troubleshoot? This is particularly frustrating because the only difference is literally the physical server. Everything else is the same.
So, every day, I move a file from my network to my client's bank. I've recently upgraded my server and move my scripts over to the new server. This WAS working on the old server.
Set up is this:
Task Scheduler executes a .bat file which runs a WinSCP script.
WinSCP Script is as follows:
open sftp://wokluprd:[password]@[bank address] cd /incoming/c21opipd lcd "\\remit\RFE-x9" put * -nopermissions -nopreservetime exit
.Bat file text which executes this follows:
# start @echo off winscp.com /script="BOATransfer-RFE.txt" /log="C:\Logs\WK\WK_log.log" # end
When I open a command line session with the bank, entering those commands one by one works perfectly. When I run the .bat file (even if I run it as an admin) it does not.
Any ideas? Anything I can do to troubleshoot? This is particularly frustrating because the only difference is literally the physical server. Everything else is the same.